When you are searching for a good recarburizer manufacturer, there are a lot of things you need to keep in mind. You should be able to identify the manufacturer you are dealing with in terms of its professional knowledge and production facilities. If you are going to produce a lot of ferroalloys, then you should consider using a recarburizer that can improve the quality of your ferroalloy products.
The recarburizer manufacturer should also be able to offer you high-quality recarburizers that are manufactured using a graphitization process. These recarburizers are produced with high carbon content, which increases the metallurgical yield of the product. This is important for the steel industry. Recarburizers can be manufactured from a variety of raw materials. Some of these include graphite, coke, petroleum coke, and charcoal.
In addition, recarburizers should also be made with good oxidation resistance. As a result, they are widely used in the steelmaking industry. Choosing the right recarburizer can reduce the cost of casting your product. Choosing the wrong one can cause excessive oxidation. Hence, you should try to find a recarburizer that is made of high-quality carbon, which will help you to make a better-quality product.
Moreover, recarburizers should be manufactured from low volatile material and have a low sulphur content. They should be manufactured with acceptable ash and alkaline metals, and they should have trace levels of transition metals.
There are several types of recarburizers available on the market, but they all differ from each other. A recarburizer can be used for casting, founding, or siderury. They are mainly derived from a variety of materials, including graphite, coal, and petroleum coke.
The first thing to do is to determine the amount of carbon you need in the molten iron solution. This can be determined by the percentage of fixed carbon and the initial carbon content of the solution. Once you have determined the correct amount, you can then determine the proportion of recarburizer you need to add. However, the amount of recarburizer should not exceed the percentage of fixed carbon in the molten iron. Moreover, the amount of recarburizer that you can use is affected by the ratio of other raw materials.
Another recarburizer is made from a synthetic graphite scrap. Graphite recarburizers can be used in high-temperature treatments to remove sulfur and nitrogen elements. Their use is increasing in the steelmaking industry.
Graphite recarburizers are usually added to the induction furnace according to the proportional requirements. Carbon recovery rate is about 50%. However, if too much recarburizer is added to the molten iron, excessive oxidation will occur. Therefore, it is a good idea to limit the use of recarburizers to the induction furnace and add a small dose to the molten iron surface.
If you are looking for a recarburizer manufacturer, you can look for Huatuo Metallurgical Co., Ltd. They have a professional team and professional production facilities for ferroalloys. Many of their customers have expressed their confusion in selecting a recarburizer.
English
Write a Message